HP ProCurve 9304M Installation And Configuration Manual page 86
Routing switches
Hide thumbs
Also See for ProCurve 9304M:
- Management and configuration manual (690 pages) ,
- Installation and getting started manual (348 pages) ,
- User manual (236 pages)
Table of Contents
Advertisement
Installation and Basic Configuration Guide
2.
Select the Redundant link to display the following panel.
3.
Click the button for the code or file you want to immediately synchronize:
•
To synchronize the running-config, select the Synchronize Configuration Now button.
•
To synchronize the boot flash code, select the Synchronize Boot Flash Now button.
As soon as you click the button, the Web management interface immediately performs the synchronization.
Automating Synchronization of Software
Automatic synchronization of the flash code, running-config, and system-config file is enabled by default.
Automatic synchronization of the boot code is disabled by default.
To change the automatic synchronization setting, use one of the following methods.
USING THE CLI
The CLI commands for automating synchronization of software between the active and standby modules is the
same as the syntax for immediately synchronizing the software. The only difference is the CLI level where you
enter the commands.
•
To immediately synchronize software, enter the command at the Privileged EXEC level.
•
To automate synchronization starting with the next software reload or system reset and each reload or reset
after that, enter the command at the Redundancy CONFIG level.
Automatic synchronization of the flash code, running-config, and system-config file is enabled by default.
Automatic synchronization of the boot code is disabled by default. To change the automatic synchronization
setting, use one of the following commands:
Syntax: [no] sync-standby boot
Syntax: [no] sync-standby code
Syntax: [no] sync-standby startup-config
Syntax: [no] sync-standby running-config [<num>]
To disable automatic synchronization of the boot code, flash code, or startup-config file, enter "no" in front of the
command.
The <num> parameter with the sync-standby running-config command specifies the synchronization interval.
You can specify from 4 – 20 seconds. The default is 10 seconds.
To disable automatic synchronization of the running-config, set the synchronization interval (the <num>
parameter) to 0.
3 - 14
Advertisement
Chapters
Table of Contents
Troubleshooting
