HP ProCurve 9304M Installation And Configuration Manual page 289

VLAN Port PVST
ID Num. Cfg.
200 10 0
200 11 1
This example shows that for VLAN 200, PVST support is statically enabled on port 11. PVST is not statically
enabled on Port 10, but because port 10 received an incoming PVST BPDU on its interface, the port converted to
using PVST mode.
Syntax: show span pvst-mode
The show span pvst-mode command displays the following information.
This Field...
VLAN ID
Port Num.
PVST cfg.
PVST on (by cfg. or detect)
USING THE WEB MANAGEMENT INTERFACE
You cannot display PVST information using the Web management interface.
Configuring Spanning Tree Protocol (STP) and Advanced STP Features
PVST
On(by cfg. or detect)
1
1
Table 8.8: CLI Display of PVST Information
Displays...
The VLAN to which the PVST/PVST+ information applies.
The HP port number.
Whether PVST support is statically enabled on the port. The value
can be one of the following:
• 0 – The support has not been statically enabled.
• 1 – The support has been statically enabled.
Whether PVST/PVST+ support is active on the port. The value can
be one of the following:
• 0 – PVST/PVST+ support is not enabled.
• 1 – PVST/PVST+ support is enabled, either because you
statically enabled the support or because the port received an
STP BPDU with PVST/PVST+ format.
8 - 83