HP ProCurve 9304M Installation And Configuration Manual page 279

Configuring Spanning Tree Protocol (STP) and Advanced STP Features
HP9300(config-vlan-12)# spanning-tree priority 2
HP9300(config-vlan-12)# tagged ethernet 1/1 ethernet to 1/4
HP9300(config-vlan-12)# vlan 13
HP9300(config-vlan-13)# tagged ethernet 1/1 ethernet to 1/4
HP9300(config-vlan-13)# vlan 14
HP9300(config-vlan-14)# tagged ethernet 1/1 ethernet to 1/4
HP9300(config-vlan-14)# exit
The following commands configure the STP groups.
HP9300(config)# stp-group 1
HP9300(config-stp-group-1)# master-vlan 2
HP9300(config-stp-group-1)# member-vlan 3 to 4
HP9300(config-stp-group-1)# exit
HP9300(config)# stp-group 2
HP9300(config-stp-group-2)# master-vlan 12
HP9300(config-stp-group-2)# member-vlan 13 to 14
Syntax: [no] stp-group <num>
This command changes the CLI to the STP group configuration level. The following commands are valid at this
level. The <num> parameter specifies the STP group ID and can be from 1 – 32.
Syntax: [no] master-vlan <num>
This command adds a master VLAN to the STP group. The master VLAN contains the STP settings for all the
VLANs in the STP per VLAN group. The <num> parameter specifies the VLAN ID. An STP group can contain
one master VLAN.
NO TE: If you delete the master VLAN from an STP group, the software automatically assigns the first member
VLAN in the group to be the new master VLAN for the group.
Syntax: [no] member-vlan <num> [to <num>]
This command adds additional VLANs to the STP group. These VLANs also inherit the STP settings of the
master VLAN in the group.
Syntax: [no] member-group <num>
This command adds a member group (a VLAN group) to the STP group. All the VLANs in the member group
inherit the STP settings of the master VLAN in the group. The <num> parameter specifies the VLAN group ID.
NO TE: This command is optional and is not used in the example above. For an example of this command, see
"Configuration Example for STP Load Sharing".
8 - 73