HP ProCurve 9304M Installation And Configuration Manual page 85

Immediately Synchronizing Software
You can immediately synchronize software between the active and standby management modules. When you
synchronize software, the active module copies the software you specify to the standby module, replacing the
software on the standby module.
To synchronize software, use either of the following methods.
USING THE CLI
To immediately synchronize the boot code on the standby module with the boot code on the active module, enter
the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby boot
Syntax: sync-standby boot
To immediately synchronize the flash code (system software) on the standby module with the boot code on the
active module, enter the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby code
Syntax: sync-standby code
NOTE: The sync-standby code command does not synchronize the TSP CPUs (non-management CPUs) on
the T-Flow. To synchronize the TSP CPUs, use the following command:
vm copy tftp flash <tftp-server-ip-addr> <image-file-name> primary | secondary
This command upgrades the TSP CPU flash code on all TSP CPUs on both T-Flow modules in the chassis.
To immediately synchronize the running-config on the standby module with the running-config on the active
module, enter the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby running-config
Syntax: sync-standby running-config
To immediately synchronize the startup-config file on the standby module with the startup-config file on the active
module, enter the following command at the Privileged EXEC level of the CLI:
HP9300# sync-standby startup-config
Syntax: sync-standby startup-config
USING THE WEB MANAGEMENT INTERFACE
NOTE: This procedure applies only to synchronizing the boot code and the running-config. To immediately
synchronize the flash code or the startup-config file, use the CLI procedure above.
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
Using Redundant Management Modules
3 - 13