HP ProCurve 9304M Installation And Configuration Manual page 120

Installation and Basic Configuration Guide
The <secs> parameter specifies the number of seconds and can be from 1 – 600 (ten minutes). The default is 60
seconds.
USING THE WEB MANAGEMENT INTERFACE
You cannot configure the parameter using the Web management interface.
Disabling SNMP Traps
HP Routing Switches come with SNMP trap generation enabled by default for all traps. You can selectively
disable one or more of the following traps.
NOTE: By default, all SNMP traps are enabled at system startup.
• SNMP authentication key
• Power supply failure
• F an failure
• Cold start
• L ink up
• L ink down
• Bridge new root
• Bridge topology change
• Locked address violation
• Module insert
• Module remove
• B GP4
• OSPF
• VRRP
• VRRPE
USING THE CLI
To stop link down occurrences from being reported, enter the following:
HP9300(config)# no snmp-server enable traps link-down
Syntax: [no] snmp-server enable traps <trap-type>
NOTE: For a list of the trap values, see the Command Line Interface Reference .
USING THE WEB MANAGEMENT INTERFACE
To enable or disable individual SNMP traps:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select the Management link to display the Management panel.
3. Click on the Trap link to display the list of traps that you can enable or disable.
4. Select the Disable or Enable button next to the trap you want to disable or enable.
5. Click the Apply button to save the change to the device's running-config file.
6. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
6 - 8