HP ProCurve 9304M Installation And Configuration Manual page 484

Installation and Basic Configuration Guide
Message Level Message
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change:
authorized
Informational DOT1X: Port <portnum>,
AuthControlledPortStatus change:
unauthorized
Informational DOT1X: Port <portnum> currently used vlan­
id changes to <vlan­id> due to dot1x­
RADIUS vlan assignment
Informational DOT1X: Port <portnum> currently used vlan­
id is set back to port default vlan­id <vlan­id>
Debug BGP4: Not enough memory available to run
BGP4
Debug DOT1X: Not enough memory
A - 32
Table A.2: HP Syslog Messages (Continued)
Explanation
The status of the interface's controlled port
has changed from unauthorized to
authorized.
The status of the interface's controlled port
has changed from authorized to
unauthorized.
A user has completed 802.1X authentication.
The profile received from the RADIUS server
specifies a VLAN ID for the user. The port to
which the user is connected has been
moved to the VLAN indicated by <vlan­id>.
The user connected to <portnum> has
disconnected, causing the port to be moved
back into its default VLAN, <vlan­id>.
The device could not start the BGP4 routing
protocol because there is not enough
memory available.
There is not enough system memory for
802.1X authentication to take place. Contact
HP Technical Support.