HP ProCurve 9304M Installation And Configuration Manual page 69

USING THE CLI
To add a module to a Chassis device:
HP9300(config)# module 3 24-port-copper-module
Syntax: module <slot-num> <module-type>
The <slot-num> parameter indicates the Chassis device slot number.
The <module-type> parameter can be one of the following. You can, of course, take advantage of the CLI's
support for abbreviated command and parameter names. (For a list of <module-type>, refer to Table 2.6 on
page 2-35.)
NOTE: Some module strings apply to more than one module. This is because the slot configuration does not
differ based on the physical layer. For example, a slot does not distinguish between an 8-port LX Fiber module
and 8-port SX Fiber module. However, the software does indicate the physical layer type when you display
module information. For example, the output of the show module command indicates the physical layer types of
each module.
Module Type
Redundant Management
modules (MII and MIV)
Management modules (MI)
(HP 9304M and HP 9308M only.
These modules will not work on
the HP 9315M)
Table 2.6: Module Options
Part Number and Description
J4845A
HP ProCurve 9300 GigLX
Redundant Management Module
(8-port)
J4846A
HP ProCurve 9300 GigSX
Redundant Management Module
(8-port)
J4847A
J4847A HP ProCurve 9300
Redundant Management Module
(0-port)
J4857A
HP ProCurve 9300 Mini-GBIC
Redundant Management Module
(8-port)
J4141A
ProCurve 9300 10/100
Management Module (16-port)
J4144A
HP ProCurve 9300 Gigabit SX
Management Module (8-port)
J4146A
HP ProCurve 9300 Gigabit 4LX/
4SX Management Module (8­
port)
Module String
8-port-gig-management-module
Discontinued
8-port-gig-management-module
Discontinued
0-port-management-module
Discontinued
8-port-gig-m4-management-
module
Discontinued
16-port-copper-management-
module
Discontinued
8-port-gig-management-module
Discontinued
8-port-gig-management-module
Discontinued
Installation
2 - 35