HP ProCurve 9304M Installation And Configuration Manual page 110

Installation and Basic Configuration Guide
Syntax: 10gig copy tftp flash <ip-addr> <filename> [module <slotnum>]
where:
• tftp – The tftp parameter indicates that the file is on a TFTP server.
• <ip-addr> – specifies the IP address of the TFTP server, if you specify tftp.
• <filename> – specifies the FPGA file name.
NOTE: You can store and copy the FPGA files using any valid filename; however, HP recommends that you
use the file names listed in the "Software Image Files" section of the release notes. The device uses
information within the files to install them in the correct FPGAs. The show flash command lists the FPGAs.
For an example of the show flash output, see "Displaying the Installed FPGA Revisions" on page 5-6.
• module <slotnum> – optionally, specifies the modules on which you want to install the upgrade. If you
do not specify a slot number, the command upgrades the FPGA on all 10 Gigabit Ethernet modules in the
chassis.
3. Reload the software by entering one of the following commands:
• reload (this command boots from the default boot source, which is the primary flash area by default)
• boot system flash primary | secondary
NOTE: The show flash command will list the new FPGA code versions but the new versions do not take
effect until you reload the software.
Displaying the Installed FPGA Revisions
To display the software versions installed in flash memory on the management module and the FPGA versions
installed on the 10 Gigabit Ethernet modules, enter the following command:
HP9300# show flash
Active management module:
Code Flash Type: AMD 29LV033C, Size: 64 * 65536 = 4194304, Unit: 4
Boot Flash Type: AMD 29LV040B, Size: 8 * 65536 = 524288
Compressed Pri Code size = 2813111, Version 07.6.04b130T53 (h2r07603b130.bin)
Compressed Sec Code size = 2799367, Version 07.6.04b79T53 (h2r07603b79.bin)
Maximum Code Image Size Supported: 6815232 (0x0067fe00)
Boot Image size = 275128, Version 07.06.04 (m2b07602.bin)
Monitor Image Version 4, for DRAM size 268435456
Used Configuration Flash Size=2092, Max Configuration Flash Size=524288.
10 GIG module slot 2
X10G RXBMGR FGPA
X10G RXPP FGPA
X10G TXACCUM FGPA
X10G TXPP FGPA
X10G AGERAM FGPA
2x10 GIG module slot 3
2X10G XTM FGPA
2X10G XPPE FGPA
Syntax: show flash
The boot code and flash code versions are listed in the "Compressed Pri Code size", "Compressed Sec Code
size", and "Boot Image size" lines of the display. The FPGA versions are listed separately for each 10 Gigabit
Ethernet module. In this example, the chassis contains a non-XENPAK-based 1-port 10 Gigabit Ethernet module
5 - 6
version: 80 revision: 6
version: 81 revision: 13
version: 82 revision: 6
version: 83 revision: 11
version: 84 revision: 4
version: 89 revision: 34
version: 88 revision: 34
2001/11/15 15:38:43
2002/06/17 17:28:53
2001/12/12 18:51:43
2002/08/16 19:15:36
2001/10/26 19:53:24
2003/02/07 01:35:52
2003/02/25 05:08:30