Ckp Sensor Removal And Installation; Engine Stop Switch Inspection - Suzuki GSX1300BK B-King Service Manual

CKP Sensor Resistance
1) Disconnect the CKP sensor coupler (1).
2) Measure the resistance between the lead wires and
ground. If the resistance is not within the standard
range, replace the CKP sensor with a new one.
Refer to "CKP Sensor Removal and Installation
(Page 1H-11)".
Tester knob indication
Resistance ( )
CKP sensor resistance
180 – 280 (Bl – Green)
(Bl – Ground)
3
2. CKP sensor coupler
3) After measuring the CKP sensor resistance, connect
the CKP sensor coupler.

CKP Sensor Removal and Installation

Refer to "Generator Removal and Installation in Section
1J (Page 1J-6)".

Engine Stop Switch Inspection

Inspect the engine stop switch in the following
procedures:
1) Turn the ignition switch OFF.
2) Remove the left fuel tank cover. Refer to "Exterior
Parts Removal and Installation in Section 9D
(Page 9D-14)".
1
I823H1180012-01
2
I718H1180008-02
3. CKP sensor
B823H11806005
B823H11806006
3) Disconnect the right handlebar switch coupler (1).
1
4) Inspect the engine stop switch for continuity with a
tester.
If any abnormality is found, replace the right
handlebar switch assembly with a new one. Refer to
"Handlebar Removal and Installation in Section 6B
(Page 6B-3)".
Special tool
: 09900–25008 (Multi-circuit tester set)
Tester knob indication
Continuity ( )
Color
B/BI
Position
( )
OFF
( )
RUN
5) After finishing the engine stop switch inspection,
reinstall the removed parts.
Ignition System: 1H-11
I823H1180014-01
B/R
I649G1180022-02