6) Stop the engine and remove the oil pressure gauge
and attachment.
7) Reinstall the main oil gallery plug (1) and tighten it to
the specified torque.
CAUTION
!
Use a new gasket to prevent oil leakage.
Tightening torque
Oil gallery plug (a): 10 N·m (1.0 kgf-m, 7.0 lbf-ft)
Engine Oil and Filter Replacement
Refer to "Engine Oil Filter Replacement" in Section 0B
(Page 0B-7).
Engine Oil Level Inspection
Refer to "Engine Oil Filter Replacement" in Section 0B
(Page 0B-7).
Oil Strainer No. 1 Removal and Installation
Refer to "Oil Strainer Inspection" in Section 0B
(Page 0B-8).
Oil Pump No. 2 Strainer Removal and
Installation
Refer to "Oil Pump No. 1 Removal and Installation"
(Page 1E-3).
Oil Strainer Inspection and Cleaning
Refer to "Oil Strainer Inspection" in Section 0B
(Page 0B-8).
NOTE
When the filter is dirtied excessively, replace
the oil sump filter with a new one.
8) Check the engine oil level. Refer to "Engine Oil Filter
Replacement" in Section 0B (Page 0B-7).
Repair Instructions
Oil Pump No. 1 Components
BA02J21506001
BA02J21506002
5
BA02J21506003
BA02J21506004
1. Oil pump driven gear
2. Oil pump No. 1 cover
3. Oil pump No. 1 plate
BA02J21506005
4. Outer rotor
5. Inner rotor
Oil Pump No. 1 Removal and Installation
Removal
1) Drain engine oil and coolant. Refer to "Engine Oil
Inspection and Replacement" in Section 0B
(Page 0B-5) and "Cooling System Inspection" in
Section 0B (Page 0B-9).
2) Remove the clutch primary driven gear assembly.
Refer to "Clutch Removal" in Section 5C (Page 5C-
7).
IA02J1150004-01
Engine Lubrication System:
1
(a)
4
3
2
(a)
6. O-ring
: 5.5 N⋅m (0.55 kgf-m, 4.0 lbf-ft)
: Apply engine oil.
: Do not reuse.
1E-3
IA02J1150003-01
BA02J21506006
6
1
IA02J1150005-01
BA02J21506007