Repair Instructions; Ignition Coil / Plug Cap And Spark Plug Removal And Installation - Suzuki GSX1300BK B-King Service Manual

1H-6 Ignition System:
Ignition Coil / Plug Cap and Spark Plug Removal
and Installation
Removal
WARNING
!
The hot engine can burn you.
Wait until the engine is cool enough to touch.
1) Turn the ignition switch OFF.
2) Remove the air cleaner box. Refer to "Air Cleaner
Box Removal and Installation in Section 1D
(Page 1D-6)".
3) Disconnect all lead wire couplers (1) from ignition
coil/plug caps (2).
1
CAUTION
!
Disconnect the lead wire coupler before
removing the ignition coil/plug cap to avoid
lead wire coupler damage.
4) Remove the ignition coils/plug caps (2).
CAUTION
!
• Do not pry up the ignition coil/plug cap
with a screwdriver or a bar to avoid its
damage.
• Be careful not to drop the ignition coil/plug
cap to prevent short/open circuit.

Repair Instructions

5) Remove the spark plugs with a spark plug wrench.
Special tool
B823H11806001
Installation
Install the spark plugs in the reverse order of removal.
Pay attention to the following points:
• Screw the spark plugs into the cylinder head with
fingers, and then tighten them to the specified torque.
CAUTION
!
Do not cross thread or over tighten the spark
plug, or such an operation will damage the
aluminum threads of the cylinder head.
I823H1180006-01
Special tool
(A): 09930–10121 (Spark plug wrench set)
Tightening torque
Spark plug: 11 N·m (1.1 kgf-m, 8.0 lb-ft)
I823H1180007-01
(A): 09930–10121 (Spark plug wrench set)
(A)
I823H1180008-01
(A)
I823H1180009-01