Power Cord Requirements; General Requirements - Compaq AlphaServer DS20E Reference Manual

The power cord set meets the requirements for use in the country where you
purchased your equipment. Power cord sets for use in other countries must
meet the requirements of the country where you use the system. For more
information on power cord set requirements, contact your Authorized Compaq
Dealer.

General Requirements

The requirements listed below are applicable to all countries:
The length of the power cord must be at least 6.0 feet (1.8 m) and a
maximum of 12 feet (3.7 m).
The power cord set must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power cord
will be used.
The power cord set must have a minimum current capacity and nominal
voltage rating of 10 A/125 volts AC, or 10A/250 volts AC, as required
by each country's power system.
The appliance coupler must meet the mechanical configuration of an
EN60320/IEC 320 Standard Sheet C13 Connector, for mating with the
appliance outlet on the system.
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: Compaq AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA. A01 File Name: o-appc.doc Last Saved On: 10/4/99 11:26 AM

Power Cord Requirements

C
Appendix