Power Cord Requirements; General Requirements - Compaq AlphaServer DS20E Reference Manual

9.5

Power Cord Requirements

The power cord set meets the requirements for use in the country
where you purchased your equipment. Power cord sets for use in other
countries must meet the requirements of the country where you use the
system. For more information on power cord set requirements, contact
your Authorized Compaq Dealer.
9.5.1

General Requirements

The requirements listed below are applicable to all countries.
•
The length of the power cord must be at least 6.0 ft (1.8 m) and a maximum
of 12 ft (3.7 m).
•
The power cord set must be approved by an acceptable accredited agency
responsible for evaluation in the country where the power cord will be used.
•
The power cord set must have a minimum current capacity and nominal
voltage rating of 10A/125 volts AC, or 10A/250 volts AC, as required by each
country's power system.
•
The appliance coupler must meet the mechanical configuration of an
EN60320/IEC 320 Standard Sheet C13 Connector, for mating with the
appliance outlet on the system.
9-8 DS20E Reference Guide
All manuals and user guides at all-guides.com