10-8 DS20E Reference Guide
Part Number: ER-K8F6W-UA .A01 File Name: k-ch10 Managing the System Remotely.doc Last Saved On: 10/4/99 1:33 PM
Command Conventions
The commands are not case sensitive.
A command must be entered in full.
You can delete an incorrect command with the Backspace key before
you press Enter.
If you type a valid RMC command, followed by extra characters, and
press Enter, the RMC accepts the correct command and ignores the extra
characters.
If you type an incorrect command and press Enter, the command fails
with the message:
*** ERROR - unknown command ***
halt
The halt command halts the managed system. The halt command is
equivalent to pressing the Halt button on the control panel and then
immediately releasing it. The RMC firmware exits command mode and
reconnects the user's terminal to the system COM1 serial port.
RMC>halt
Focus returned to COM port
The halt command can be used to force a halt assertion.
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: AlphaServer DS20E System Comments: