Dual Processor System Power-Up
If a processor fails to correctly initialize on a system power-up, perform the
following procedure:
1. Verify that both processors are present by using the Show CPU
command.
2. If only one processor is present, press the Reset button.
NOTE: Allow 30 seconds following a power-down before you re-power the system to
avoid a rapid cycle. If a rapid cycle occurs, check that both processors are present. If
they are not present, press the Reset button.
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: Compaq AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA .A01 File Name: i-ch8 Installing Components.doc Last Saved On: 10/4/99 2:40 PM
Installing Components 8-9