Compaq AlphaServer DS20E Reference Manual page 195

haltin
The haltin command halts a managed system and forces a halt assertion. The
haltin command is equivalent to pressing the Halt button on the control panel
and holding it in. This command can be used at any time after system power-
up to allow you to perform system management tasks.
haltout
The haltout command terminates a halt assertion that was done with the
haltin command. It is equivalent to releasing the Halt button on the control
panel after holding it in (rather than pressing it once and releasing it
immediately). This command can be used at any time after system power-up.
help or ?
The help or ? command displays the RMC firmware commands.
poweroff
The poweroff command requests the RMC to power off the system. The
poweroff command is equivalent to pressing the On/Off button on the control
panel to the off position.
RMC>poweroff
If the system is already powered off or if switch 3 (RPD DIS) on the switch
pack has been set to the on setting (disabled), this command has no immediate
effect.
To power the system on again after using the poweroff command, you must
issue the poweron command.
If, for some reason, it is not possible to issue the poweron command, the local
operator can start the system as follows:
1. Press the On/Off button to the off position and disconnect the power
cord.
2. Reconnect the power cord and press the On/Off button to the on
position.
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA .A01 File Name: k-ch10 Managing the System Remotely.doc Last Saved On: 10/4/99 1:33 PM
Managing the System Remotely 10-9