Compaq AlphaServer DS20E Reference Manual page 269

pk*0_soft_term
Enables or disables SCSI terminators. This command applies to systems that
use the QLogic ISP1040 SCSI controller.
The QLogic ISP1040 SCSI controller implements the 16-bit wide SCSI bus.
The QLogic module has two terminators, one for the low eight bits and one for
the high eight bits.
The syntax is:
set pk*0_soft_term value
The options for value are:
off
low (default)
high
on
diff
tt_allow_login
Enables or disables login to the SRM console firmware on alternate console
ports. If the environment variable console is set to serial, the primary console
device is the terminal connected through the COM1 port. The command set
tt_allow_login 1 enables logins through either the COM2 port or a graphics
monitor.
The syntax is:
set tt_allow_login value
The options for value are:
0
1 (default)
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA .A01 File Name: l-ch11 Using the SRM Console.doc Last Saved On: 10/4/99 2:05 PM
Disables termination of all 16 bits.
Enables low eight bits and disables high eight bits.
Enables high eight bits and disables low eight bits.
Enables all 16 bits.
Places the bus in differential mode.
Disables login through the COM2 port or a graphics monitor.
Enables login through the COM2 port or a graphics monitor.
Using the SRM Console 11-63