Compaq AlphaServer DS20E Reference Manual page 197

quit
The quit command exits the user from command mode and reconnects the
serial terminal to the system console port. The following message is
displayed:
Focus returned to COM port
The next display depends on what the system was doing when the RMC was
invoked. For example, if the RMC was invoked from the SRM console
prompt, the console prompt will be displayed when you enter a carriage return.
Or, if the RMC was invoked from the operating system prompt, the operating
system prompt will be displayed when you enter a carriage return.
reset
The reset command requests the RMC to reset the hardware. The reset
command is equivalent to pressing the Reset button on the control panel.
RMC>reset
Focus returned to COM port
The following events occur when the reset command is executed:
The system restarts and the system console firmware reinitializes.
The console exits RMC command mode and reconnects the serial
terminal to the system COM1 serial port.
The power-up messages are displayed, and then the console prompt is
displayed or the operating system boot messages are displayed,
depending on how the startup sequence has been defined.
Compaq Confidential – Need to Know Required
Writer: Robert Young Project: AlphaServer DS20E System Comments:
Part Number: ER-K8F6W-UA .A01 File Name: k-ch10 Managing the System Remotely.doc Last Saved On: 10/4/99 1:33 PM
Managing the System Remotely 10-11