Océ | Media System
When stabilizing is complete, printer status information is displayed.
Take-up Roll Reattachment
3.3.3
Follow these steps to remove a partial take-up roll and reattach media to a new empty take-
up core:
1.
Press the Load Media button. You then see:
Load Media
new supply roll?
2.
Press the Menu button. You then see:
Load Media
reattach takeup?
3.
Press the ACCEPT button. You then see:
Use +/- keys, attach
takeup, press ACCEPT
The take-up dancer moves automatically up and out of the way.
4.
To unload the partial roll of images, gently open the front door completely.
5.
Cut the media below the take-up dancer and remove the take-up mandrel from the
printer (see Figure 3-15).
Drive Roll
Figure 3-15 Cutting Media Above Take-up Dancer
Note: Avoid cutting into the media drive roller or the Teflon coating on the take-
3-16
Take-up
Dancer
Take-up
Mandrel
up dancer.