Chapter 2
Catalyst 3750-X and 3560-X Switch Cisco IOS Commands
logging event power-inline-status
Syntax Description
Defaults
Command Modes
Command History
Usage Guidelines
Examples
Related Commands
OL-21522-02
Downloaded from
www.Manualslib.com
Use the logging event power-inline-status interface configuration command to enable the logging of
Power over Ethernet (PoE) events. Use the no form of this command to disable the logging of PoE status
events; however, the no form of this command does not disable PoE error events.
logging event power-inline-status
no logging event power-inline-status
power-inline-status
Logging of PoE events is enabled.
Interface configuration
Release
12.2(53)SE2
The power-inline-status keyword is available only on PoE interfaces.
This example shows how to enable logging of PoE events on a port:
Switch(config-if)# interface gigabitethernet1/0/1
Switch(config-if)# logging event power-inline-status
Switch(config-if)#
Command
power inline
show controllers
power inline
manuals search engine
Enable the logging of PoE messages.
Modification
This command was introduced.
Description
Configures the power management mode for the specified PoE port or for all
PoE ports.
Displays the values in the registers of the specified PoE controller.
Catalyst 3750-X and 3560-X Switch Command Reference
logging event power-inline-status
2-331