Power Inline Usage-Threshold; Power Inline Traps Enable - Cisco 300 Series Cli Manual

25
378
25.4

power inline usage-threshold

Use the power inline usage-threshold Global Configuration mode command to
configure the threshold for initiating inline power usage alarms. Use the no form of
this command to restore the default configuration.
Syntax
power inline usage-threshold
no power inline usage-threshold
Parameters
percent—Specifies the threshold in percent to compare to the measured power.
(Range: 1–99)
Default Configuration
The default threshold is 95 percent.
Command Mode
Global Configuration mode
Example
The following example configures the threshold for initiating inline power usage
alarms to 90 percent.
switchxxxxxx(config)# power inline usage-threshold 90
25.5

power inline traps enable

Use the power inline traps enable Global Configuration mode command to enable
inline power traps. Use the no form of this command to disable traps.
Syntax
power inline traps enable
no power inline traps enable
Power over Ethernet (PoE) Commands
percent
78-21075-01 Command Line Interface Reference Guide