Honda 2004 Odyssey Service Manual page 470

9. Measure resistance between the terminals of the
indicated sensor on the PCM connector (see table).
PCM CONNECTOR A (31P)
TDC1 (GRN)
TDC2
(YEL)
TDC1 (RED)
TDC2 (BLK)
Wire side of female terminals
SENSOR DTC SENSOR
TERMINAL
TDC1 P1361
P1362
TDC2 P1366
P1367
Is there 1,850 2,450
YES Go to step 10.
NO Repair open in the indicated sensor wires (see
table).
10. Check for continuity between body ground and
PCM connector terminal A10 and/or A11
individually.
PCM CONNECTOR A (31P)
TDC2
(YEL)
TDC1 (GRN)
Wire side of female terminals
Is there continuity?
YES Repair short in the indicated sensor wires
(see table).
NO Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
PCM WIRE
TERMINAL COLOR
1 A11 GRN
2 A23 RED
3 A10 YEL
4 A22 BLK
?
DTC P1676 '99-00 Models:
Line Failure
1. Reset the PCM (see page 11-4).
2. Start the engine, and wait 10 seconds.
Is DT C P167 6 indicated?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the ABS/TCS control unit and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect PCM connector E (12P) and the
ABS/TCS control unit 16P connector.
5. Check for continuity between body ground and
PCM connector terminal E1.
PCM CONNECTOR E (12P)
FPTDR
(PNK/BLK)
Wire side of female terminals
Is there continuity?
YES Repair short in the wire between the ABS/
TCS control unit and the PCM (E1).
NO Go to step 6.
FPTDR Signal
(cont'd)
11-161 11-161