Honda 2004 Odyssey Service Manual page 469

PGM-FI System
DTC Troubleshooting (cont'd)
DTC P1361 '01 Model:
Intermittent Interruption
DTC P1362 '01 Model:
No Signal
DTC P1366 '01 Model:
Intermittent Interruption
DTC P1367 '01 Model:
No Signal
1. Reset the PCM (see page 11-4).
2. Start the engine.
Is DT C P1361, P1362, P1366, or P1367
indicated?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the TDC1/TDC2 sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the TDC1/TDC2 sensor 4P connector.
5. Measure resistance between the terminals of
indicated sensor (see table).
TDC1/TDC2 SENSOR 4P CONNECTOR
TDC1
TDC2
Terminal side of male terminals
11-160
TDC Sensor 1 Circuit
TDC Sensor 1 Circuit
TDC Sensor 2 Circuit
TDC Sensor 2 Circuit
TDC1
TDC2
SENSOR DTC SENSOR
TERMINAL
TDC1 P1361
P1362
TDC2 P1366
P1367
Is there 1,850 2,450
YES Go to step 6.
NO Replace the TDC1/TDC2 sensor
(see page 6-60).
6. Check for continuity to body ground on both
terminals of the indicated sensor individually.
TDC1/TDC2 SENSOR 4P CONNECTOR
TDC1
TDC2
Terminal side of male terminals
Is there continuity?
YES Replace the TDC1/TDC2 sensor
(see page 6-60).
NO Go to step 7.
7. Reconnect the TDC1/TDC2 sensor 4P connector.
8. Disconnect PCM connector A (31P).
PCM WIRE
TERMINAL COLOR
1 A11 GRN
2 A23 RED
3 A10 YEL
4 A22 BLK
?
TDC1
TDC2