Igmp Query Commands (Layer 2) - Planet SGSD-1022 User Manual

---- --------------- ------------ ------
1 224.1.2.3 Eth1/11 IGMP
Console#

5.25.2 IGMP Query Commands (Layer 2)

This section describes commands used to configure Layer 2 IGMP query on the switch.
Command
ip igmp snooping querier
ip igmp snooping query-count
ip igmp snoopingquery-interval
ip igmp
snoopingquery-max-response-ti
me
ip igmp
snoopingrouter-port-expire-time
ip igmp snooping querier
This command enables the switch as an IGMP querier. Use the no form to disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration
Command Usage
IGMP snooping querier is not supported for IGMPv3 snooping (see ip igmp snooping version, page 4-300).
If enabled, the switch will serve as querier if elected. The querier is responsible for asking hosts if they want to receive
multicast traffic.
Example
Console(config)#ip igmp snooping querier
Console(config)#
Function
Allows this device to act as the querier for IGMP snooping
Configures the query count
Configures the query interval
Configures the report delay
Configures the query timeout
Table 5-86 IGMP Query Commands (Layer 2)
646
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Mode
GC
GC
GC
GC
GC