Lldp Mednotification - Planet SGSD-1022 User Manual

therefore periodically check the value of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp notification
Console(config-if)#

lldp mednotification

This command enables the transmission of SNMP trap notifications about LLDP-MED changes. Use the no form to disable
LLDP-MED notifications.
Syntax
[no] lldp mednotification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option sends out SNMP trap notifications to designated target stations at the interval specified by the lldp
notification-interval command. Trap notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), the LLDP-MED MIB (ANSI/TIA 1057), or oganization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
SNMP trap destinations are defined using the snmp-server host command.
Information about additional changes in LLDP neighbors that occur between SNMP notifications is not transmitted.
Only state changes that exist at the time of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp mednotification
Console(config-if)#
lldp basic-tlv management-ip-address
This command configures an LLDP-enabled port to advertise the management address for this device. Use the no form to
disable this feature.
User's Manual of SGSD-1022 / SGSD-1022P
603
SGSW-2840 / SGSW-2840P