Show Map Access-List - Planet SGSD-1022 User Manual

show map access-list

This command shows the CoS queue mapped to an ACL for the current interface.
Syntax
show map access-list {ip | mac} [interface]
ip - Specifies IP ACLs.
mac - Specifies MAC ACLs.
interface
-ethernet unit/port
-unit - This is device 1.
-port - Port number.
Command Mode
Privileged Exec
Example
Console#show map access-list ip
Eth 1/1
access-list ip aclname cos 3
Console#
5.24 Quality of Service Commands
The commands described in this section are used to configure Differentiated Services (DiffServ) classification criteria and
service policies. You can classify traffic based on access lists, IP Precedence or DSCP values, or VLANs. Using access lists
allows you select traffic based on Layer 2, Layer 3, or Layer 4 information contained in each packet.
Command
class-map
match
policy-map
class
set
police
service-policy
show class-map
Function
Creates a class map for a type of traffic
Defines the criteria used to classify traffic
Creates a policy map for multiple interfaces
Defines a traffic classification for the policy to act on
Classifies IP traffic by setting a CoS, DSCP value in a packet
Defines an enforcer for classified traffic
Applies a policy map defined by the policy-map command to the
input of a particular interface
Displays the QoS class maps which define matching criteria
used for classifying traffic
632
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Mode
GC
CM
GC
PM
PM-C
PM-C
IC
PE