Switchport Voice Vlan Rule - Planet SGSD-1022 User Manual

the switchport voice vlan command (page 4-251). When OUI is selected, be sure to configure the MAC address ranges
in the Telephony OUI list.
Example
The following example sets port 1 to Voice VLAN auto mode.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan auto
Console(config-if)#

switchport voice vlan rule

This command selects a method for detecting VoIP traffic on a port. Use the no form to disable the selected detection method
on a port.
Syntax
[no] switchport voice vlan rule {oui | lldp}
• oui - Traffic from VoIP devices is detected by the Organizationally Unique Identifier (OUI) of the source MAC address.
• lldp - Uses LLDP to discover VoIP devices attached to the port.
Default Setting
OUI: Enabled
LLDP: Disabled
Command Mode
Interface Configuration
Command Usage
When OUI is selected, be sure to configure the MAC address ranges in the Telephony OUI list (see the voice vlan
mac-address command). MAC address OUI numbers must be configured in the Telephony OUI list so that the switch
recognizes the traffic as being from a VoIP device.
LLDP checks that the "telephone bit" in the system capability TLV is turned on. See "LLDP Commands" for more
information on LLDP.
Example
The following example enables the OUI method on port 1 for detecting VoIP traffic.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport voice vlan rule oui
Console(config-if)#
User's Manual of SGSD-1022 / SGSD-1022P
593
SGSW-2840 / SGSW-2840P