Enable Password - Planet SGSD-1022 User Manual

The device has two predefined privilege levels:
0: Normal Exec, 15: Privileged Exec.
nopassword - No password is required for this user to log in.
{0 | 7} - 0 means plain password, 7 means encrypted password.
password password - The authentication password for the user. (Maximum length: 8 characters plain text, 32 encrypted,
case sensitive)
Default Setting
The default access level is Normal Exec.
The factory defaults for the user names and passwords are:
Command Mode
Global Configuration
Command Usage
The encrypted password is required for compatibility with legacy password settings (i.e., plain text or encrypted) when
reading the configuration file during system bootup or when downloading the configuration file from a TFTP server. There
is no need for you to manually configure encrypted passwords.
Example
Example
This shows how to set the access level and password for a user.
Console(config)#username bob access-level 15
Console(config)#username bob password 0 smith
Console(config)#

enable password

After initially logging onto the system, you should set the Privileged Exec password. Remember to record it in a safe place. This
command controls access to the Privileged Exec level from the Normal Exec level. Use the no form to reset the default
password.
username
Guest
admin
Table 5-28 Default Login Settings
User's Manual of SGSD-1022 / SGSD-1022P
Access level
0
15
424
SGSW-2840 / SGSW-2840P
password
Guest
admin