Lldp Refresh-Interval - Planet SGSD-1022 User Manual

management.
Information about changes in LLDP neighbors that occur between SNMP notifications is not transmitted. Only state
changes that exist at the time of a notification are included in the transmission. An SNMP agent should therefore
periodically check the value of lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
Example
Console(config)#lldp notification-interval 30
Console(config)#

lldp refresh-interval

This command configures the periodic transmit interval for LLDP advertisements. Use the no form to restore the
Setting
.
Syntax
lldp refresh-interval seconds
no lldp refresh-delay
seconds - Specifies the periodic interval at which LLDP advertisements are sent. (Range: 5 - 32768 seconds)
Default Setting
30 seconds
Command Mode
Global Configuration
Command Usage
This attribute must comply with the following rule:
(refresh-interval * holdtime-multiplier)
Example
Console(config)#lldp refresh-interval 60
Console(config)#
lldp reinit-delay
This command configures the delay before attempting to re-initialize after LLDP ports are disabled or the link goes down.
Use the no form to restore the
Syntax
lldp reinit-delay seconds
no lldp reinit-delay
65536
Default Setting
.
User's Manual of SGSD-1022 / SGSD-1022P
600
SGSW-2840 / SGSW-2840P
Default