Sta Port Configuration - Planet SGSD-1022 User Manual

4.7.1.4 STA Port Configuration

Configuring Interface Settings
You can configure RSTP and MSTP attributes for specific interfaces, including port priority, path cost, link type, and edge port.
You may use a different priority or path cost for ports of the same media type to indicate the preferred path, link type to indicate a
point-to-point connection or shared-media connection, and edge port to indicate if the attached device can support fast
forwarding. (References to "ports" in this section means "interfaces," which includes both ports and trunks.)
The following attributes are read-only and cannot be changed:
Object
STA State
Trunk
Spanning Tree
Figure 4-7-7 STA Port Configuration page screenshot
Description
Displays current state of this port within the Spanning Tree.
(See "Displaying Interface Settings" for additional information.)
Discarding - Port receives STA configuration messages, but does not forward
packets.
Learning - Port has transmitted configuration messages for an interval set by
the Forward Delay parameter without receiving contradictory information. Port
address table is cleared, and the port begins learning addresses.
Forwarding -Port forwards packets, and continues learning addresses.
Indicates if a port is a member of a trunk.
(STA Port Configuration only)
Enables/disables STA on this interface.
(Default: Enabled).
165
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P