Quality Of Service - Planet SGSD-1022 User Manual

4.10 Quality of Service

This Managed Switch prioritizes each packet based on the required level of service, using four priority queues with strict priority,
Weighted Round Robin, or hybrid queuing. It uses IEEE 802.1p and 802.1Q tags to prioritize incoming traffic based on input
from the end-station application. These functions can be used to provide independent priorities for delay-sensitive data and
best-effort data.
This Managed Switch also supports several common methods of prioritizing layer 3/4 traffic to meet application requirements.
Traffic can be prioritized based on the IPv4 header Type-of-Service field using DSCP, IP Precedence, IP TOS values, or
TCP/UDP port numbers. When these services are enabled, the priorities are mapped to a Class of Service output queue.
Quality of Service – Differentiated Services (DiffServ) provides policy-based management mechanisms used for prioritizing
network resources to meet the requirements of specific traffic types on a per-hop basis. Each packet is classified upon entry into
the network based on access lists, IP Precedence or DSCP values, or VLAN lists. Using access lists allows you select traffic
based on Layer 2, Layer 3, or Layer 4 information contained in each packet. Based on network policies, different kinds of traffic
can be marked for different kinds of forwarding.
This section has the following items:
Priority
Default Port Priority
Default Trunk Priority
Traffic Classes
Queue Mode
Queue Scheduling
IP DSCP Priority Status
IP DSCP Priority
IP Port Priority Status
IP Port Priority
IP Precedence Priority
Status
IP Precedence Priority
IP TOS Priority Status
IP TOS Priority
ACL CoS Priority
DiffServ
Class Map
Policy Map
Sets the default priority for each port
Sets the default priority for each trunk
Maps IEEE 802.1p priority tags to output queues
Sets queue mode to strict, Weighted Round-Robin, or hybrid
Configures Weighted Round Robin queueing
Globally enables DSCP priority
Sets IP Differentiated Services Code Point priority, mapping a DSCP tag to a
class-of-service queue
Globally enables IP port priority
Sets IP port priority, mapping TCP/UDP ports to class-of-service queues
Globally enables IP precedence priority
Sets IP precedence priority, mapping IP precedence values to class-of-service
queues
Globally enables IP ToS priority
Sets IP ToS priority, mapping IP ToS values to class-of-service queues
Sets ACL priority, mapping IP and MAC ACLs to class-of-service queues
Configures QoS classification criteria and service policies
Sets Class Maps
Sets Policy Maps
225
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P