Show Ip Source-Guard Binding - Planet SGSD-1022 User Manual

Eth 1/1 DISABLED
Eth 1/2 DISABLED
Eth 1/3 DISABLED
Eth 1/4 DISABLED
Eth 1/5 SIP
Eth 1/6 DISABLED

show ip source-guard binding

This command shows the source guard binding table.
Syntax
show ip source-guard binding [dhcp-snooping | static]
dhcp-snooping - Shows dynamic entries configured with DHCP Snooping commands (see page 4-146)
static - Shows static entries configured with the ip source-guard binding command (see page 4-155).
Command Mode
Privileged Exec
Access Control List Commands
Example
Console# show ip source-guard binding
MacAddress
----------------------
11-22-33-44-55-66 192.168.0.99
Console#
5.14 Access Control List Commands
Access Control Lists (ACL) provide packet filtering for IP frames (based on address, protocol, or Layer 4 protocol port number or
TCP control code) or any frames (based on MAC address or Ethernet type). To filter packets, first create an access list, add the
required rules and then bind the list to a specific port. This section describes the Access Control List commands.
Command Grup
IP ACLs
MAC ACLs
ACL Information
IpAddress Lease(sec)
------------------ ----------
Function
Configures ACLs based on IP addresses, TCP/UDP port
number, andprotocol type
Configures ACLs based on hardware addresses, packet format,
and Ethernet type
Displays ACLs and associated rules; shows ACLs assigned to
each port
User's Manual of SGSD-1022 / SGSD-1022P
Type VLAN Interface
-------- ------ -----------
0 Static 1 Eth 1/5
496
SGSW-2840 / SGSW-2840P