Configure A Standard Acl - Planet SGSD-1022 User Manual

4.11.13.2 Configure a Standard ACL

1. Specify the action (i.e., Permit or Deny).
2. Select the address type (Any, Host, or IP). If you select "Host," enter a specific address.
3. If you select "IP," enter a subnet address and the mask for an address range.
4. Then click Add.
The page includes the following fields:
Object
Action
Address Type
IP Address
Subnet Mask
Figure 4-11-34 Settings screenshot
Description
An ACL can contain any combination of permit or deny rules.
Specifies the source IP address. Use "Any" to include all possible addresses,
"Host" to specify a specific host address in the Address field, or "IP" to specify a
range of addresses with the Address and SubMask fields. (Options: Any, Host,
IP; Default: Any)
Source IP address.
A subnet mask containing four integers from 0 to 255, each separated by a
period. The mask uses 1 bits to indicate "match" and 0 bits to indicate "ignore."
The mask is bitwise ANDed with the specified source IP address, and compared
with the address for each IP packet entering the port(s) to which this ACL has
been assigned.
308
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P