Lacp System-Priority - Planet SGSD-1022 User Manual

Flow control
status:
Port security:
Max MAC count:
Current status:
Created by:
Link status:
Operation speed-duplex: 100full
Flow control type:
Member Ports: Eth1/11, Eth1/12, Eth1/13,
Console#

lacp system-priority

This command configures a port's LACP system priority. Use the no form to restore the
Syntax
lacp {actor | partner} system-priority priority
no lacp {actor | partner} system-priority
actor - The local side an aggregate link.
partner - The remote side of an aggregate link.
priority -This priority is used to determine link aggregation group (LAG) membership, and to identify this device to other
switches during LAG negotiations. (Range: 0-65535)
Default Setting
32768
Command Mode
Interface Configuration (Ethernet)
Command Usage
Port must be configured with the same system priority to join the same LAG.
System priority is combined with the switch's MAC address to form the LAG identifier. This identifier is used to indicate a
specific LAG during LACP negotiations with other systems.
Once the remote side of a link has been established, LACP operational settings are already in use on that side.
Configuring LACP settings for the partner only applies to its administrative state, not its operational state, and will only
take effect the next time an aggregate link is established with the partner.
Disabled
Disabled
0
LACP
Up
None
User's Manual of SGSD-1022 / SGSD-1022P
527
SGSW-2840 / SGSW-2840P
Default Setting
.