Channel-Group - Planet SGSD-1022 User Manual

Dynamically Creating a Port Channel –
Ports assigned to a common port channel must meet the following criteria:
Ports must have the same LACP system priority.
Ports must have the same port admin key (Ethernet Interface).
If the port channel admin key (lacp admin key -Port Channel) is not set when a channel group is formed (i.e., it has the null value
of 0), this key is set to the same value as the port admin key (lacp admin key -Ethernet Interface) used by the interfaces that
joined the group.
However, if the port channel admin key is set, then the port admin key must be set to the same value for a port to be allowed to
join a channel group.
If a link goes down, LACP port priority is used to select the backup link.

channel-group

This command adds a port to a trunk. Use the no form to remove a port from a trunk.
Syntax
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-12)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
When configuring static trunks, the switches must comply with the Cisco EtherChannel standard.
Use no channel-group to remove a port group from a trunk.
Use no interfaces port-channel to remove a trunk from the switch.
Example
Example
The following
Console(config)#interface port-channel 1
Console(config-if)#exit
Console(config)#interface ethernet 1/11
Console(config-if)#channel-group 1
Console(config-if)#
lacp
This command enables 802.3ad Link Aggregation Control Protocol (LACP) for the current interface. Use the no form to disable
creates trunk 1 and then adds port 11:
User's Manual of SGSD-1022 / SGSD-1022P
525
SGSW-2840 / SGSW-2840P