Lldp Admin-Status - Planet SGSD-1022 User Manual

lldp admin-status

This command enables LLDP transmit, receive, or transmit and receive mode on the specified port. Use the no form to disable
this feature.
Syntax
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx -Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp admin-status rx-only
Console(config-if)#
lldp notification
This command enables the transmission of SNMP trap notifications about LLDP changes.
Use the no form to disable LLDP notifications.
Syntax
[no] lldp notification
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option sends out SNMP trap notifications to designated target stations at the interval specified by the lldp
notification-interval command (page 4-257). Trap notifications include information about state changes in the LLDP MIB
(IEEE 802.1AB), or organization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
SNMP trap destinations are defined using the snmp-server host command (page 4-72).
Information about additional changes in LLDP neighbors that occur between SNMP notifications is not transmitted.
Only state changes that exist at the time of a trap notification are included in the transmission. An SNMP agent should
User's Manual of SGSD-1022 / SGSD-1022P
602
SGSW-2840 / SGSW-2840P