Show Port Monitor - Planet SGSD-1022 User Manual

Console(config-if)#port monitor ethernet 1/6 both
Console(config-if)#

show port monitor

This command displays mirror information.
Syntax
show port monitor [interface] interface -ethernet unit/port (source port)
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28)
Default Setting
Shows all sessions.
Command Mode
Privileged Exec
Command Usage
This command displays the currently configured source port, destination port, and mirror mode (i.e., RX, TX, RX/TX).
Example
The following shows mirroring configured from port 6 to port 11:
Console(config)#interface ethernet 1/11
Console(config-if)#port monitor ethernet 1/6 rx
Console(config-if)#end
Console#show port monitor
Port Mirroring
Destination port(listen port):Eth1/11
Source port(monitored port) :Eth1/6
Mode :RX
Console#
5.18 Rate Limit Commands
This function allows the network manager to control the maximum rate for traffic received on an interface. Rate limiting is
configured on interfaces at the edge of a network to limit traffic into the network. Packets that exceed the acceptable amount of
traffic are dropped.
Rate limiting can be applied to individual ports. When an interface is configured with this feature, the traffic rate will be monitored
User's Manual of SGSD-1022 / SGSD-1022P
536
SGSW-2840 / SGSW-2840P