Dot1X Re-Authentication - Planet SGSD-1022 User Manual

intrusion-action on page 4-124).
Example
Console#dot1x re-authenticate
Console#

dot1x re-authentication

This command enables periodic re-authentication globally for all ports. Use the no form to disable re-authentication.
Syntax
[no] dot1x re-authentication
Command Mode
Interface Configuration
Command Usage
The re-authentication process verifies the connected client's user ID and password on the RADIUS server. During
re-authentication, the client remains connected the network and the process is handled transparently by the dot1x client
software. Only if re-authentication fails is the port blocked or the user assigned to the Guest VLAN (see dot1x
intrusion-action on page 4-124).
The connected client is re-authenticated after the interval specified by the dot1x timeout re-authperiod command. The
default is 3600 seconds.
Example
Console(config)#interface eth 1/2
Console(config-if)#dot1x re-authentication
Console(config-if)#
Related Commands
dot1x timeout re-authperiod
dot1x timeout quiet-period
This command sets the time that a switch port waits after the Max Request Count has been exceeded before attempting to
acquire a new client. Use the no form to reset the default.
Syntax
dot1x timeout quiet-period seconds
User's Manual of SGSD-1022 / SGSD-1022P
463
SGSW-2840 / SGSW-2840P