Dot1Q-Tunnel System-Tunnel-Control - Planet SGSD-1022 User Manual

dot1q-tunnel system-tunnel-control

This command sets the switch to operate in QinQ mode. Use the no form to disable QinQ operating mode.
Syntax
[no] dot1q-tunnel system-tunnel-control
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
QinQ tunnel mode must be enabled on the switch for QinQ interface settings to be functional.
Example
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#
Related Commands
show dot1q-tunnel
show interfaces switchport
switchport dot1q-tunnel mode
This command configures an interface as a QinQ tunnel port. Use the no form to disable QinQ on the interface.
Syntax
switchport dot1q-tunnel mode {access | uplink}
no switchport dot1q-tunnel mode
access – Sets the port as an 802.1Q tunnel access port.
uplink – Sets the port as an 802.1Q tunnel uplink port.
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
QinQ tunneling must be enabled on the switch using the dot1q-tunnel system-tunnel-control command before the
switchport dot1q-tunnel mode interface command can take effect.
When a tunnel uplink port receives a packet from a customer, the customer tag (regardless of whether there are one or
User's Manual of SGSD-1022 / SGSD-1022P
577
SGSW-2840 / SGSW-2840P