Smtp Alert Commands - Planet SGSD-1022 User Manual

[0] 00:00:37 2001-01-01
"System coldStart notification."
level: 6, module: 5, function: 1, and event no.: 1
Console#

5.8 SMTP Alert Commands

These commands configure SMTP event handling, and forwarding of alert messages to the specified SMTP servers and email
recipients.
Command
logging sendmail host
logging sendmail level
logging sendmail source-email
logging sendmail
destination-email
logging sendmail
show logging sendmail
logging sendmail host
This command specifies SMTP servers that will be sent alert messages. Use the no form to remove an SMTP server.
Syntax
[no] logging sendmail host ip_address
ip_address - IP address of an SMTP server that will be sent alert messages for event handling.
Default Setting
None
Command Mode
Global Configuration
Command Usage
You can specify up to three SMTP servers for event handing. However, you must enter a separate command to specify
each server.
To send email alerts, the switch first opens a connection, sends all the email alerts waiting in the queue one by one, and
finally closes the connection.
To open a connection, the switch first selects the server that successfully sent mail during the last connection, or the first
Function
SMTP servers to receive alert messages
Severity threshold used to trigger alert messages
Email address used for "From" field of alert messages
Email recipients of alert messages
Enables SMTP event handling
Displays SMTP event handler settings
Table 4-18 SMTP Alert Commands
395
User's Manual of SGSD-1022 / SGSD-1022P
SGSW-2840 / SGSW-2840P
Mode
GC
GC
GC
GC
GC
NE, PE