Silent-Time - Planet SGSD-1022 User Manual

Command Mode
Line Configuration
Command Usage
When the logon attempt threshold is reached, the system interface becomes silent for a specified amount of time before
allowing the next logon attempt. (Use the silent-time command to set this interval.) When this threshold is reached for
Telnet, the Telnet logon interface shuts down.
This command applies to both the local console and Telnet connections.
Example
To set the password threshold to five attempts, enter this command:
Console(config-line)#password-thresh 5
Console(config-line)#
Related Commands

silent-time

timeout login response
silent-time
This command sets the amount of time the management console is inaccessible after the number of unsuccessful logon
attempts exceeds the threshold set by the password-thresh command. Use the no form to remove the silent time value.
Syntax
silent-time [seconds]
no silent-time
seconds -The number of seconds to disable console response.
(Range: 0-65535; 0: no silent-time)
Default Setting
The default value is no silent-time.
Command Mode
Line Configuration
Example
To set the silent time to 60 seconds, enter this command:
Console(config-line)#silent-time 60
Console(config-line)#
Related Commands
password-thresh
databits
This command sets the number of data bits per character that are interpreted and generated by the console port. Use the no
User's Manual of SGSD-1022 / SGSD-1022P
384
SGSW-2840 / SGSW-2840P