Timeout Login Response - Planet SGSD-1022 User Manual

user can enter an incorrect password before the system terminates the line connection and returns the terminal to the idle
state.
The encrypted password is required for compatibility with legacy password settings (i.e., plain text or encrypted) when
reading the configuration file during system bootup or when downloading the configuration file from a TFTP server. There
is no need for you to manually configure encrypted passwords.
Example
Console(config-line)#password 0 secret
Console(config-line)#
Related Commands
login
password-thresh

timeout login response

This command sets the interval that the system waits for a user to log into the CLI. Use the no form to restore the default.
Syntax
timeout login response [seconds] no timeout login response
seconds - Integer that specifies the timeout interval.
(Range: 0 -300 seconds; 0: disabled)
Default Setting
CLI: Disabled (0 seconds)
Telnet: 600 seconds
Command Mode
Line Configuration
Command Usage
If a login attempt is not detected within the timeout interval, the connection is terminated for the session.
This command applies to both the local console and Telnet connections.
The timeout for Telnet cannot be disabled.
Using the command without specifying a timeout restores the default setting.
Example
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
Related Commands
User's Manual of SGSD-1022 / SGSD-1022P
382
SGSW-2840 / SGSW-2840P