Sntp Server - Planet SGSD-1022 User Manual

sntp server

This command sets the IP address of the servers to which SNTP time requests are issued. Use the this command with no
arguments to clear all time servers from the current list.
Syntax
sntp server [ip1 [ip2 [ip3]]] ip - IP address of a time server (NTP or SNTP). (Range: 1-3 addresses)
Default Setting
None
Command Mode
Global Configuration
Command Usage
This command specifies time servers from which the switch will poll for time updates when set to SNTP client mode. The
client will poll the time servers in the order specified until a response is received. It issues time synchronization requests
based on the interval set via the sntp poll command.
Example
Console(config)#sntp server 10.1.0.19
Console(config)#
Related Commands
sntp client
sntp poll
show sntp
sntp poll
This command sets the interval between sending time requests when the switch is set to SNTP client mode. Use the no form to
restore to the default.
Syntax
sntp poll seconds
no sntp poll
seconds - Interval between time requests. (Range: 16-16384 seconds)
Default Setting
16 seconds
Command Mode
Global Configuration
Example
User's Manual of SGSD-1022 / SGSD-1022P
400
SGSW-2840 / SGSW-2840P