Map Access-List Ip - Planet SGSD-1022 User Manual

Console#
Related Commands
ip access-group

map access-list ip

This command sets the output queue for packets matching an ACL rule. The specified CoS value is only used to map the
matching packet to an output queue; it is not written to the packet itself. Use the no form to remove the CoS mapping.
Syntax
[no] map access-list ip acl_name cos cos-value
acl_name – Name of the ACL. (Maximum length: 16 characters)
cos-value – CoS value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet)
Command Usage
You must configure an ACL before you can map CoS values to the rule.
A packet matching a rule within the specified ACL is mapped to one of the output queues as shown in the following table.
For information on mapping the CoS values to output queues, see
Example
Console(config)# interface ethernet 1/2
Console(config-if)#map access-list ip bill cos 0
Console(config-if)
Related Commands
queue cos-map
show map access-list ip
Priority 1,2
Queue 0
Table 5-48 Egress Queue Priority Mapping
User's Manual of SGSD-1022 / SGSD-1022P
queue cos-map.
0,3 4,5
1 2
503
SGSW-2840 / SGSW-2840P
6,7
3