Cli Commands: Quality Of Service; Cli Commands: Access Control List; Show Ip Access-Lists; Configuration Commands - Planet WGSW-24000 User Manual

9. CLI COMMANDS: QUALITY OF SERVICE

This chapter provides a detailed explanation of the Quality of Service (QOS) commands. The following
QOS CLI commands are available in the software QOS Package.
The commands are divided into these different groups:
▫ Show commands are used to display device settings, statistics and other information.
▫ Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.

9.1 CLI Commands: Access Control List

Access Control Lists (ACLs) ensure that only authorized users have access to specific resources while
blocking off any unwarranted attempts to reach network resources.

9.1.1 show ip access-lists

This command displays an Access Control List (ACL) and all of the rules that are defined for the ACL.
The <accesslistnumber> is the number used to identify the ACL.
▫
Format show ip access-lists <accesslistnumber>
▫
Mode Privileged EXEC and User EXEC
▫ Rule Number - This displays the number identifier for each rule that is defined for the ACL.
▫ Action - This displays the action associated with each rule. The possible values are Permit or
Deny.
▫ Protocol - This displays the protocol to filter for this rule.
▫ Source IP Address - This displays the source IP address for this rule.
▫ Source IP Mask - This field displays the source IP Mask for this rule.
▫ Source Ports - This field displays the source port range for this rule.
▫ Destination IP Address - This displays the destination IP address for this rule.
▫ Destination IP Mask - This field displays the destination IP Mask for this rule.
▫ Destination Ports - This field displays the destination port range for this rule.
▫ Service Type Field Match - This field indicates whether an IP DSCP, IP Precedence, or IP TOS
match condition is specified for this rule.
▫ Service Type Field Value - This field indicates the value specified for the Service Type Field Match
(IP DSCP, IP Precedence, or IP TOS).

9.2 Configuration Commands

9.2.1 access-list

This command creates an Access Control List (ACL) that is identified by the parameter