Table of Contents
Advertisement
4.3 Setting 1000BASE-X for 10G SFP+ Port
The Managed Switch supports both 1000BASE-X and 10GBASE-X SFP
transceivers by manual setting and the default SFP+ port speed is set to 10Gbps.
For example, to establish the fiber connection with 1000BASE-X SFP transceiver in
the Ethernet 1/0/1, the following command configuration is required:
Switch# config
Switch(config)# interface ethernet 1/0/1
Switch(config-if-ethernet 1/0/1)# speed-duplex force1g-full
Switch(config-if-ethernet 1/0/1)# exit
4.4 Changing Password
The default password of the switch is "admin". For security reason, it is
recommended to change password and the following command configuration is
required:
Switch# config
Switch(config)# username admin password planet2018
Switch(config)#
4.5 Saving the Configuration
In the Managed Switch, the running configuration file stores in the RAM. In the
current version, the running configuration sequence running-config can be saved
from the RAM to FLASH by write command or copy running-config startup-
config command, so that the running configuration sequence becomes the start-up
configuration file, which is called configuration save.
Switch# copy running-config startup-config
Write running-config to current startup-config successful
9
Advertisement
Table of Contents
