10.1.4 Communication setting display operation
1
Channel-Driver assign operation
The following describes how to operate the Channel-Driver assign.
The example of changing to direct CPU connection (Communication driver: "A/QnA/L/QCPU, L/
QJ71C24") for the GOT of computer link connection (Communication driver: [AJ71QC24, MELDAS
C6*]) is used.
Before the operation
(Continued to next page)
The GOT automatically restarts after executing this setting.
If project data has been downloaded, the GOT starts monitoring of the controller
after restarting.
Execute this setting after carefully confirming the safety.
10.1.4 Communication setting display operation
1
Install communication driver "A/QnA/L/
QCPU, L/QJ71C24" to GOT.
(Download of [Communication Setting]
from GT Designer3 or GT Designer2 is not
required.)
After installing communication driver, touch
the
Channel Driver assign
[Communication Setting].
2
Touch the
Change assignment
the dislayed screen as shown left.
10.1 Communication Setting
9
10
11
12
button in
13
button on
14
15
16
10
- 7