Mitsubishi GOT1000 GT15 User Manual page 549

Error
Error message
code
Warning! Built-in Flash
505 ROM needs replacement
soon.
Warning! Backlight needs
506
replacement.
Warning! Display section
507
needs replacement.
Warning! Touch panel
508
needs replacement.
Warning! Built-in Flash
509 ROM needs replacement.
Change the GOT.
Clock data input out of
510
range
A blown backlight is
511
detected.
Action
The dedicated GS is notifying that the built-in flash memory
writing times have reached 80% or more of the set times.
The GOT must be replaced. In that case, Data backup and re-
setting are needed. The GOT can also be restored by turning
off the notification signal manually. In such a case, turn it OFF
after setting a value greater than the addition times.
The dedicated GS is notifying that the backlight power on
addition time has reached the set time or more.
The GOT can be restored by executing the addition times
reset function after replacing the backlight. The GOT can also
be restored by turning off the notification signal manually. In
such a case, turn it OFF after setting a value greater than the
addition time.
The dedicated GS is notifying that the display section power
on addition time has reached the set time or more.
The GOT can be restored by executing the addition times
reset function after replacing the display section. The GOT
can also be restored by turning off the notification signal
manually. In such a case, turn it OFF after setting a value
greater than the addition time.
The dedicated GS is notifying that the touching count of the
touch key has reached the set count number or more.
The GOT can be restored by executing the addition times
reset function after replacing the touch key. The GOT can also
be restored by turning off the notification signal manually. In
such a case, turn it OFF after setting a value greater than the
addition times.
The dedicated GS is notifying that the built-in flash memory
writing times have reached the set times or more.
The GOT must be replaced. In that case, Data backup and re-
setting are needed. The GOT can also be restored by turning
off the notification signal manually. In such a case, turn it OFF
after setting a value greater than the addition times.
The value that is input as clock data is out of the input
enabled range.
In this case, the input value is not accepted.
Confirm the input range of the value to be input as clock data,
and input the proper value again.
The backlight is shut off or the lighting status of the backlight
is unstable.
If the error is detected repeatedly, contact your local
Mitsubishi representative.
20.3 ERROR MESSAGE AND SYSTEM ALARM
20.3.2 List of Error Message/System Alarm
17
Channel
No.
storage
18
19
20
20
- 29