Table of Contents
Advertisement
Precautions for communications between GOT and controller
(1) Installing communication driver and downloading Communication Setting
The followings below are required for the communication interface to
communicate with the controller.
1) Installing communication drivers (Up to 4 communication drivers)
2) Assigning the channel number and communication driver for the
communication interface
3) Downloading the contents (project data) assigned in 2).
Perform1), 2), 3) by GT Designer3 or GT designer2.
• GOT1000 Series Connection Manual for GT Works3 and a
controller used (1.1 Setting the Communication Interface)
• GT Designer2Version
(3.7 Communication Interface Setting (Communication Settings))
• GT Designer3 Version1 Screen Design Manual (Fundamentals)
(7.3.7 Reading project data)
• GT Designer2Version
(8.3.1 Downloading project data [PC to GOT])
(2) When Communication Setting has not been downloaded.
The GOT automatically assigns the installed communication driver in the order of
1 to 4 as follows.(Only the extend interface is assigned automatically.)
1)
3)
1) ChNo.1, Communication driver installed at 1st
2) ChNo.2, Communication driver installed at 2nd
3) ChNo.3, Communication driver installed at 3rd
4) ChNo.4, Communication driver installed at 4th
(a) After communication driver is assigned automatically.
When saving the settings to the GOT with
assignment of communication driver, automatic assignment will not be
performed at the next time and after.
Refer to the following for details.
Screen Design Manual
Basic Operation/Data Transfer Manual
10.1 Communication Setting
10.1.3 Communication setting contents
2)
4)
button after the automatic
OK
9
10
11
12
13
14
15
16
10
- 5
Advertisement
Table of Contents
Troubleshooting
