Table of Contents
Advertisement
6
Tighten the extend interface relay board installed by the step
range (0.36 to 0.48N·m). (2 places)
Removing the MELSECNET/H communication unit, CC-Link IE Controller Network
communication unit, CC-Link IE Field Network communication unit, CC-Link
communication unit (GT15-J61BT13)
Before removing the unit, unscrew the extend interface relay board fixing screws.
(
7
When installing an extension unit on the unit that has been installed, refer to the following.
8.1.3 Installing multiple extension units in layers
When not installing an extension unit on the unit that has been installed, in order to avoid
receiving electrostatic, stick accessory labels to cover the top of mounting screws (4 places).
Keep the connector cover fixed.
Keep the sticker stuck as it is.
(2) Terminal block socket installation (For GT15-J61BT13 only)
1
Insert the terminal block socket in CC-Link communication unit.
)
above
A
within the specified torque
8.1 Communication Unit
8.1.2 Installing procedure
1
2
3
4
5
6
7
8
8
- 13
Advertisement
Table of Contents
Troubleshooting
